Reference Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
in | out | both Enter the keyword in, out, or both to debug incoming
interfaces, outgoing interfaces, or both incoming and
outgoing interfaces.
vlan vlan-id Enter the keyword vlan followed by the VLAN id number
from 1 to 4094.
count value Enter the keyword count followed by the number of debug
outputs. The range is 1 to 100.
Defaults Debug disabled.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
S5000
Syntax
protocol-tunnel {stp}
To disable protocol tunneling for a Layer 2 protocol, use the no protocol-
tunnel
command.
Parameters
stp Enter the keyword stp to enable protocol tunneling on a
spanning tree, including STP, MSTP, RSTP, and PVST.
Defaults none
Command
Modes
CONF-IF-VLAN
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell#conf
Dell(conf)#interface vlan 2
1252
Service Provider Bridging