Reference Guide

RADIUS Commands
The Dell Networking OS supports the following RADIUS commands.
debug radius
View RADIUS transactions to assist with troubleshooting.
S5000
Syntax
debug radius
To disable debugging of RADIUS, use the no debug radius command.
Defaults Disabled.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
S5000
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16838.
• For the Null interface, enter the keywords null 0.
Security
1215