Reference Guide

flush Enter the number of seconds to specify the time interval
during which the route is advertised as unreachable. When
this interval expires, the route is flushed from the routing
table. The flush value should be greater than the update
value. The range is zero (0) to 4294967295. The default is
240 seconds.
Defaults
• update = 30 seconds
• invalid = 180 seconds
• holddown = 180 seconds
• flush = 240 seconds
Command
Modes
ROUTER RIP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you change the timers on one router, the timers on all routers in the RIP domain
must also be synchronized.
version
Specify either RIP version 1 or RIP version 2.
S5000
Syntax
version {1 | 2}
To return to the default version setting, use the no version command.
Parameters
1 Enter the keyword 1 to specify RIP version 1.
2 Enter the keyword 2 to specify RIP version 2.
Defaults The Dell Networking OS sends RIPv1 and receives RIPv1 and RIPv2.
Command
Modes
ROUTER RIP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
ip rip receive version – sets the RIP version to be received on the interface.
ip rip send version – sets the RIP version to be sent out the interface.
Routing Information Protocol (RIP)
1167