Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To enable RIP, you must assign a network address using the network command.
Example
Dell(conf)#router rip
Dell(conf-router_rip)#
Related
Commands
network – enables RIP.
exit – returns to CONFIGURATION mode.
show config
Display the changes you made to the RIP configuration. Default values are not shown.
S5000
Syntax
show config
Command
Modes
ROUTER RIP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface TenGigabitEthernet 0/1
Dell(conf-router_rip)#
show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
S5000
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format
to view RIP information on that network only. If you enter an
IP address, you must also enter a mask for that IP address.
mask (OPTIONAL) Specify a mask, in /network format, for the IP
address.
1164
Routing Information Protocol (RIP)