Reference Guide

Usage
Information
When the offset metric is applied to an interface, that value takes precedence over
an offset value that is not extended to an interface.
Related
Commands
ip prefix-list – enters PREFIX-LIST mode and configure a prefix list.
output-delay
Set the interpacket delay of successive packets to the same neighbor.
S5000
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no
output-delay command.
Parameters
delay Specify a number of milliseconds as the delay interval. The
range is 8 to 50.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command is intended for low-speed interfaces.
passive-interface
Suppress routing updates on a specified interface.
S5000
Syntax
passive-interface interface-type slot/port
To delete a passive interface, use the no passive-interface interface-
type slot/port
command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information.
Valid slot numbers are 0-11. The valid port numbers for each
interface type are listed below.
1160
Routing Information Protocol (RIP)