Reference Guide

neighbor
Define a neighbor router with which to exchange RIP information.
S5000
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address Enter the IP address, in dotted decimal format, of a router
with which to exchange information.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple
neighbor routers are possible.
Use the passive-interface command in conjunction with the neighbor
command to ensure that only specific interfaces are receiving and sending data.
Related
Commands
passive-interface – sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the
switch.
S5000
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Defaults No RIP network is configured.
Command
Modes
ROUTER RIP
1158
Routing Information Protocol (RIP)