Reference Guide

Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you want the interface to receive both versions of RIP, use the ip rip receive
version 1 2 command.
Related
Commands
ip rip send version – sets the RIP version to be used for sending RIP traffic on an
interface.
version – sets the RIP version to be used for the switch software.
ip rip send version
Set the interface to send a specific version of RIP. The version you set on the interface overrides the
version command in ROUTER RIP mode.
S5000
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1 (OPTIONAL) Enter the number 1 for RIP version 1. The
default is RIPv1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Defaults RIPv1
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To enable the interface to send both version of RIP packets, use the ip rip send
version 1 2 command.
Related
Commands
ip rip receive version – sets the RIP version for the interface to receive traffic.
version – sets the RIP version to be used for the switch software.
1156
Routing Information Protocol (RIP)