Reference Guide

• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
ip prefix-list – enters PREFIX-LIST mode and configures a prefix list.
distribute-list out
Configure a filter for outgoing routing updates.
S5000
Syntax
distribute-list prefix-list-name out [interface-type slot/port
| bgp | connected | ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out
command.
Parameters
prefix-list-
name out
Enter the name of a configured prefix list followed by the
keyword out.
interface-type
slot/port
(OPTIONAL) Enter the interface type and slot/port or number
information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
connected (OPTIONAL) Enter the keyword connected to filter only
directly connected routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually
configured routes.
1154
Routing Information Protocol (RIP)