Reference Guide

Parameters
weight Enter a number from 1 to 255 for the weight (for
prioritization). The default is 120.
ip-address (OPTIONAL) Enter the IP address, in dotted decimal format
(A.B.C.D), of the host or network to receive the new distance
metric.
mask If you enter an IP address, you must also enter a mask for
that IP address, in either dotted decimal format or /prefix
format (/x).
prefix-name (OPTIONAL) Enter a configured prefix list name.
Defaults weight = 120
Command
Modes
ROUTER RIP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
default-metric – assigns one distance metric to all routes learned using the
redistribute command.
distribute-list in
Configure a filter for incoming routing updates.
S5000
Syntax
distribute-list prefix-list-name in [interface-type slot/port]
To delete the filter, use the no distribute-list prefix-list-name in
command.
Parameters
prefix-list-
name in
Enter the name of a configured prefix list followed by the
keyword in.
interface-type
slot/port
(OPTIONAL) Enter the interface type and slot/port or number
information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
Routing Information Protocol (RIP)
1153