Reference Guide

match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
S5000
Syntax
match ip access-group access-group-name [set-ip-dscp value]
To remove ACL match criteria from a class map, use the no match ip access-
group access-group-name [set-ip-dscp value] command.
Parameters
access-group-
name
Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class specified
by class-map.
set-ip-dscp
value
(OPTIONAL) Enter the keywords set-ip-dscp followed by
the IP DSCP value. The matched traffic is marked with the
DSCP value. The range is 0 to 63.
Defaults none
Command
Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must enter the class-map command in order to access this command. After
the class map is identified, you can configure the match criteria. For class-map
match-any, a maximum of five ACL match criteria are allowed. For class-map
match-all
, only one ACL match criteria is allowed.
Related
Commands
class-map – identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
S5000
Syntax
match ip dscp dscp-list
To remove a DSCP value as a match criteria, use the no match ip dscp dscp-
list
command.
Parameters
dscp-list Enter the IP DSCP value(s) that is to be the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is 0 to
63.
Quality of Service (QoS)
1113