Reference Guide

Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p Priority: 0 1 2 3 4 5 6 7
• CoS Queue: 0 0 0 1 2 3 3 3
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p
command.
Related
Commands
show qos dot1p-queue-mapping – displays the dot1p priority to queue mapping
on the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all
interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE
mode entries.
S5000
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command. The default mapping is as follows:
Table 10. Default Mapping for 802.1p Traffic
dot1p Priority Value Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Quality of Service (QoS)
1107