Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(conf)#ipv6 pim register-filter REG-FIL_ACL
Dell(conf)#ipv6 access-list REG-FIL_ACL
Dell(conf-ipv6-acl)#deny ipv6 165:87:34::10/128 ff0e::
225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any any
Dell(conf-ipv6-acl)#exit
ipv6 pim rp-address
Configure a static PIM rendezvous point (RP) address for a group. This address is used by first-hop routers
to send register packets on behalf of the source multicast host.
S5000
Syntax
ipv6 pim rp-address address group-address group-address mask
override
To remove an RP address, use the no ipv6 pim re-address address group-
address mask override command.
Parameters
address Enter the IPv6 RP address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
group-address
group-address
mask
Enter the keywords group-address followed by the group
address in the x:x:x:x::x format and then the mask in /nn
format to assign that group address to the RP.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
override Enter the keyword override to override the BSR updates
with static RP. The override takes effect immediately during
enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
1074
PIM-Sparse Mode (PIM-SM)