Reference Guide

ipv6 pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the
PIM-SM router from creating state based on multicast source and/or group.
S5000
Syntax
ipv6 pim join-filter access-list
Parameters
access-list Enter the name of an extended access list.
in Enter the keyword in to apply the access list to inbound
traffic.
out Enter the keyword out to apply the access list to outbound
traffic.
Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(conf)#ipv6 access-list JOIN-FIL_ACL
Dell(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::
225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any
Dell(conf-ipv6-acl)#exit
Dell(conf)#interface tengigabitethernet 0/84
Dell(conf-if-te-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in
Dell(conf-if-te-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
S5000
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds
command.
Parameters
seconds Enter a number as the number of seconds between router
query messages. The range is 0 to 65535. The default is 30
seconds.
1072
PIM-Sparse Mode (PIM-SM)