Reference Guide

Usage
Information
The following describes output from the show ip pim snooping neighbor
command shown in the Example below.
Field Description
Neighbor
address
Displays the IP address of the neighbor learned through PIM-
SM snooping.
Interface Displays the VLAN ID number and slot/port on which the
PIM-SM-enabled neighbor was discovered.
Uptime/expires Displays the amount of time the neighbor has been up
followed by the amount of time until the neighbor is
removed from the multicast routing table (that is, until the
neighbor hold time expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim
dr-priority
command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [Te 4/13 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [Te 4/11 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [Te 4/20 ] 00:00:51/00:01:24 v2 0
show ip pim snooping tib
Display information from the tree information base (TIB) discovered by PIM-SM snooping about multicast
group members and states.
S5000
Syntax
show ip pim snooping tib [vlan vlan-id] [group-address [source-
address]]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display TIB information
discovered by PIM-SM snooping on a specified VLAN. The
valid VLAN IDs range is 1 to 4094.
1062
PIM-Sparse Mode (PIM-SM)