Reference Guide

Usage
Information
The following describes output from the show ip pim neighbor command
shown in the Example below.
Field Description
Neighbor
address
Displays the IP address of the PIM neighbor.
Interface List the interface type, with either slot/port information or ID
(VLAN or Port Channel), on which the PIM neighbor was
found.
Uptime/expires Displays the amount of time the neighbor has been up
followed by the amount of time until the neighbor is
removed from the multicast routing table (that is, until the
neighbor hold time expires).
Ver Displays the PIM version number.
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode.
• 1 = default Designated Router priority (use the ip pim
dr-priority
command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Prio/Mode
127.87.3.4 Te 7/16 09:44:58/00:01:24 v2 1 / S
Dell#
show ip pim rp
View all multicast groups-to-RP mappings.
S5000
Syntax
show ip pim rp [mapping | group-address]
Parameters
mapping (OPTIONAL) Enter the keyword mapping to display the
multicast groups-to-RP mapping and information on how
RP is learnt.
group-address (OPTIONAL) Enter the multicast group address mask in
dotted decimal format to view RP for a specific group.
PIM-Sparse Mode (PIM-SM)
1059