Reference Guide

Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. The range is 1 to 128.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
priority (OPTIONAL) Enter the priority used in Bootstrap election
process. The range is zero (0) to 255. The default is 192.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ip pim snooping
Enable PIM-SM snooping globally on a switch or on a VLAN interface.
S5000
Syntax
ip pim snooping [enable]
To disable PIM-SM snooping, use the no ip pim snooping [enable]
command.
Defaults Disabled.
Command
Modes
• CONFIGURATION: To configure PIM-SM snooping globally, enter the ip pim
snooping enable
command in global configuration mode.
• VLAN INTERFACE: To configure PIM-SM snooping on a VLAN interface, enter
the ip pim snooping command in VLAN interface configuration mode.
PIM-Sparse Mode (PIM-SM)
1053