Reference Guide

Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(conf)# ip access-list standard map1
Dell(config-std-nacl)# permit 224.0.0.1/24
Dell(config-std-nacl)#exit
Dell(conf)#int tengig 1/1
Dell(config-if-te-1/1)# ip pim ingress-interface-map map1
ip pim neighbor-filter
Configure this feature to prevent a router from participating in protocol independent multicast (PIM).
S5000
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-
list} command.
Parameters
access-list Enter the name of a standard access list. Maximum 16
characters.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Do not enter this command before creating the access-list.
ip pim query-interval
Change the frequency of PIM Router-Query messages.
S5000
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds
command.
1050
PIM-Sparse Mode (PIM-SM)