Reference Guide

ip pim bsr-border
Define the border of PIM domain by filtering inbound and outbound PIM-BSR messages per interface.
S5000
Syntax
ip pim bsr-border
To return to the default value, use the no ip pim bsr-border command.
Defaults Disabled.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command is applied to the subsequent PIM-BSR. Existing BSR advertisements
are cleaned up by time out. Candidate RP advertisements can be cleaned using the
clear ip pim rp-mapping command.
ip pim bsr-candidate
Configure the PIM router to join the Bootstrap election process.
S50000
Syntax
ip pim bsr-candidate interface-type slot/port [hash-mask-
length] [priority]
To return to the default value, use the no ip pim bsr-candidate command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information.
Valid slot numbers are 0-11. The valid port numbers for each
interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
1046
PIM-Sparse Mode (PIM-SM)