Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
seq
Configure a filter with an assigned sequence number for the redirect list.
S5000
Syntax
seq sequence-number {permit | redirect {ip-address} {ip-
protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit]
[operator]
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the
permit list.
redirect Enter the keyword redirect to assign the sequence to the
redirect list.
ip-address Enter the IP address of the forwarding router.
ip-protocol-
number
ip-protocol-number Enter a number from 0 to 255 for the
protocol identified in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to
the filter.
host ip-address Enter the keyword host followed by the IP address to
specify a host IP address.
destination destination Enter the IP address of the network or host to
which the packets are sent.
1040
Policy-based Routing (PBR)