Reference Guide

timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path first
(SPF) calculation.
S5000
Syntax
timers spf delay holdtime
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is 0 to 4294967295.
The default is 5 seconds.
holdtime Enter a number as the hold time. The range is 0 to
4294967295. The default is 10 seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command
Modes
ROUTER OSPF
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Setting the delay and holdtime parameters to a low number enables the switch to
switch to an alternate path quickly but requires more CPU usage.
timers throttle lsa all
Configure LSA transmit intervals.
S5000
Syntax
timers throttle lsa all {start-interval | hold-interval | max-
interval}
To return to the default, use the no timers throttle lsa command.
Parameters
start-interval Set the minimum interval between initial sending and
resending the same LSA. The range is 0 to 600,000
milliseconds.
hold-interval Set the next interval to send the same LSA. This is the time
between sending the same LSA after the start-interval has
been attempted. The range is 1 to 600,000 milliseconds.
1032
Open Shortest Path First (OSPFv2)