Reference Guide

ping
Test connectivity between the system and another device by sending echo requests and waiting for
replies.
S5000
Syntax
ping [host | ip-address | [count {number | continuous}]
[datagram-size] [timeout] [ip src-ipv4-address | source-
interface-type slot/port] [tos] [df-bit (y|n)] [validate-
reply(y|n)] [outgoing-interface] [pattern pattern] [sweep-min-
size] [sweep-max-size] [sweep-interval] [outgoing-interface (ip
src-ipv4-address) | outgoing-interface-type slot/port]
Parameters
host (OPTIONAL) Enter the host name of the devices to which
you are testing connectivity.
ip-address (OPTIONAL) Enter the IPv4 address of the device to which
you are testing connectivity. The address must be in the
dotted decimal format.
count Enter the number of echo packets to be sent. Default: 5.
• number: 1- 2147483647
• continuous: transmit echo request continuously
datagram size Enter the ICMP datagram size. Range: 36 - 15360 bytes.
Default: 100.
timeout Enter the interval to wait for an echo reply before timing out.
Range: 0 -3600 seconds. Default: 2 seconds.
source-
interface-type
slot/port
Enter the IPv4 source ip address or the source interface.
Enter the IP address in A.B.C.D format.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
tos (IPv4 only) Enter the type of service required. Range: 0-255.
Default: 0.
df-bit (IPv4 only) Enter Y or N for the “don't fragment” bit in IPv4
header.
• N: Do not set the “don't fragment” bit.
Control and Monitoring
103