Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell#show ip ospf 10 timers rate-limit
List of LSAs in rate limit Queue
LSA id: 1.1.1.0 Type: 3 Adv Rtid: 3.3.3.3 Expiry time:
00:00:09.111
LSA id: 3.3.3.3 Type: 1 Adv Rtid: 3.3.3.3 Expiry time:
00:00:23.96
Dell#
show ip ospf topology
Display routers in directly connected areas.
S5000
Syntax
show ip ospf process-id topology
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use this command to isolate problems with inter-area and external routes. In OSPF
inter-area and external routes are calculated by adding LSA cost to the cost of
reaching the router. If an inter-area or external route is not of correct cost, the
display can determine if the path to the originating router is correct or not.
Example
Dell#show ip ospf 1 topology
Router ID Flags Cost Nexthop Interface Area
3.3.3.3 E/B/-/ 1 20.0.0.3 Te 13/1 0
1.1.1.1 E/-/-/ 1 10.0.0.1 Te 7/1 1
Dell#
Open Shortest Path First (OSPFv2)
1029