Reference Guide

Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output from the show ip ospf statistics process-
id global command shown in the Example below.
Total Displays the total number of packets received/transmitted by
the OSPF process.
Error Displays the error count while receiving and transmitting
packets by the OSPF process.
Hello Number of OSPF Hello packets.
DDiscr Number of database description packets.
LSReq Number of link state request packets.
LSUpd Number of link state update packets.
LSAck Number of link state acknowledgement packets.
TxQ-Len The transmission queue length.
RxQ-Len The reception queue length.
Tx-Mark The highest number mark in the transmission queue.
Rx-Mark The highest number mark in the reception queue.
Hello-Q The queue, for transmission or reception, for the hello
packets.
LSR-Q The queue, for transmission or reception, for the link state
request packets.
Other-Q The queue, for transmission or reception, for the link state
acknowledgement, database description, and update
packets.
The following describes the error definitions for the show ip ospf statistics
process-id global command.
Intf_Down Received packets on an interface that is either down or OSPF
is not enabled.
Non-Dr Received packets with a destination address of ALL_DRS
even though SELF is not a designated router.
Self-Org Receive the self originated packet.
Wrong_Len The received packet length is different to what was indicated
in the OSPF header.
Invld-Nbr LSA, LSR, LSU, and DDB are received from a peer which is
not a neighbor peer.
1026
Open Shortest Path First (OSPFv2)