Reference Guide

Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
show ip ospf database – displays OSPF database information.
show ip ospf database router
Display the router (type 1) LSA information.
S5000
Syntax
show ip ospf process-id database router [link-state-id] [adv-
router ip-address]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
link-state-id (OPTIONAL) Specify LSA ID in dotted decimal format. The
LSA ID value depends on the LSA type, and it can be one of
the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4
LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router ip-
address
(OPTIONAL) Enter the keywords adv-router followed by
the IP address of an Advertising Router to display only the
LSA information about that router.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output for the show ip ospf process-id database
router command shown in the Example below.
LS Age Displays the LSA age.
Options Displays the optional capabilities available on router. The
following options can be found in this item:
• TOS-capability or No TOS-capability is displayed
depending on whether the router can support Type of
Service.
Open Shortest Path First (OSPFv2)
1017