Reference Guide

Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must have an IP address assigned to an interface to enter ROUTER OSPF mode
and configure OSPF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF
Process ID again in the system.
Example
Dell(conf)#router ospf 2
Dell(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
S5000
Syntax
show config
Command
Modes
ROUTER OSPF
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface tengigabitethernet 0/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
S5000
Syntax
show ip ospf process-id
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Open Shortest Path First (OSPFv2)
1003