Reference Guide

Related
Commands
ip ssh server – enables the secure shell (SSH) server on the system.
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
S5000
Syntax
ip telnet source-interface type slot/port
Parameters
source-
interfacetype
slot/port
Enter the source-interface keyword followed by the
interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
telnet – telnets to another device.
100
Control and Monitoring