Users Guide

Related
Commands
neighbor default-originate – injects the default route.
show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Parameters
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prefix length
in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
summary Display a summary of RPF routes.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
show ip bgp ipv6 unicast
View the current MBGP route table.
C-Series, E-Series, S4810
Syntax
show ip bgp ipv6 unicast [network [network-mask] [length]]
Paramters
network (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP
network to view information only on that network.
network-mask (OPTIONAL) Enter the keywords network mask (in slash prefix format) of the
BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a
common prefix.
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The following describes the show ip bgp ipv6 unicast command shown in the Example below.
IPv6 Border Gateway Protocol (IPv6 BGP) 915