Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000

911

912

913

914

915

916

917

918

919

920

Command Modes ROUTER BGPV6-ADDRESS FAMILY

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.4.2.1 Introduced on the C-Series and S4810.

Version 7.4.1.0 Introduced on the E-Series TeraScale.

Usage

Information

The software resolves the network address configured by the network command with the routes in the

main routing table to ensure that the networks are reachable using non-BGP routes and non-default

routes.

Commands

redistribute – redistributes routes into BGP.

redistribute

Redistribute routes into BGP.

Syntax

redistribute {connected | static} [route-map map-name]

To disable redistribution, use the no redistribution {connected | static} command.

Parameters

connected Enter the keyword connected to redistribute routes from physically connected

interfaces.

static Enter the keyword static to redistribute manually configured routes. These

routes are treated as incomplete routes.

route-map

map-

name

(OPTIONAL) Enter the keywords route-map followed by the name of an

established route map. Only the following ROUTE-MAP mode commands are

supported:

● match ipv6 address

● match ipv6 next-hop

● match ipv6 route-source

● set ipv6 next-hop

If the route map is not configured, the default is deny (to drop all routes).

Defaults Not configured.