Users Guide

Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group to remove the private AS numbers.
Defaults Disabled (that is, the private AS number are not removed).
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {ipv6-address | peer-group-name} route-map map-name {in | out}
To remove the route map, use the no neighbor {ipv6-address | peer-group-name}
route-map map-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group.
map-name Enter the name of an established route map. If the Route map is not configured,
the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route
map used in this command. If you identify a peer by IP address, the Route map overwrites either the
inbound or outbound policies on that peer.
912 IPv6 Border Gateway Protocol (IPv6 BGP)