Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000

901

902

903

904

905

906

907

908

909

910

Parameters

ipv6-address

Enter the IPv6 address in the x:x:x:x::x format.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

peer-group-name

Enter the name of the peer group to set the default route of all routers in that peer

group.

route-map

map-

name

(OPTIONAL) Enter the keywords route-map then the name of a configured route

map.

Defaults Not configured.

Command Modes ROUTER BGPV6-ADDRESS FAMILY

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.4.2.1 Introduced on the C-Series and S4810.

Version 7.4.1.0 Introduced on the E-Series TeraScale.

neighbor distribute-list

Distribute BGP information using an established prefix list.

Syntax

neighbor {ipv6-address | peer-group-name} distribute-list prefix-list-name

{in | out}

To delete a neighbor distribution list, use the no neighbor {ipv6-address | peer-group-

name} distribute-list prefix-list-name {in | out} command.

Parameters

ipv6-address

Enter the IPv6 address in the x:x:x:x::x format.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

peer-group-name

Enter the name of the peer group.

prefix-list-name

Enter the name of an established prefix list. If the prefix list is not configured, the

default is permit (to allow all routes).

in Enter the keyword in to distribute only inbound traffic.

out Enter the keyword out to distribute only outbound traffic.