Users Guide

match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPFv3
internal routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name of an
established route map. Only the following ROUTE-MAP mode commands are
supported:
● match ipv6 address
● match ipv6 next-hop
● match ipv6 route-source
● set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When you enter the redistribute ospf process-id command without any other parameters, Dell
Networking OS redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes.
router bgp
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as- number Enter the AS number. The range is from 1 to 65535.
Defaults Not enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
IPv6 Border Gateway Protocol (IPv6 BGP) 885