Users Guide

redistribute isis
Redistribute IS-IS routes into BGP.
Syntax
redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value |
metric-type {external | internal}] [route-map map-name]
To stop redistribution of IS-IS routes, use the no redistribute isis command.
Parameters
level-1 | level-1-2
| level-2]
(OPTIONAL) Enter the type (level) of routes to redistribute.
metric (OPTIONAL) Assign metric to an interface for use with IPv6 information.
metric-type (OPTIONAL) The external link type associated with the default route advertised
into a routing domain. You must specify one of the following:
● external
● internal (default)
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of an established
route map. Only the following ROUTE-MAP mode commands are supported:
● match ipv6 address
● match ipv6 next-hop
● match ipv6 route-source
● set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
redistribute ospf
Redistribute OSPFv3 routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]]
[route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is from 1 to 65535.
match external {1
| 2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF external
routes. You can specify 1 or 2 to redistribute those routes only.
884 IPv6 Border Gateway Protocol (IPv6 BGP)