Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000

881

882

883

884

885

886

887

888

889

890

mask

Enter the mask of the IP address in the slash prefix length format (for

example, /24). The mask appears in command outputs in dotted decimal format

(A.B.C.D).

route-map

map-

name

(OPTIONAL) Enter the keywords route-map followed by the name of an

established route map. Only the following ROUTE-MAP mode commands are

supported:

● match ipv6 address

● match ipv6 next-hop

● match ipv6 route-source

● set ipv6 next-hop

If the route map is not configured, the default is deny (to drop all routes).

Defaults Not configured.

Command Modes ROUTER BGPV6-ADDRESS FAMILY

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.4.2.1 Introduced on the C-Series and S4810.

Version 8.2.1.0 Introduced on the E-Series ExaScale.

Version 7.4.1.0 Introduced on the E-Series TeraScale.

Usage

Information

The software resolves the network address configured by the network command with the routes in the

main routing table to ensure that the networks are reachable using non-BGP routes and non-default

routes.

Commands

redistribute – redistributes routes into BGP.

network backdoor

Specify this IGP route as the preferred route.

Syntax

network ipv6-address prefix-length backdoor

To remove a network, use the no network ipv6-address prefix-length backdoor

command.

Parameters

ipv6-address

prefix-length

Enter the IPv6 address in the x:x:x:x::x format then the prefix length in the /x

format. The range is from /0 to /128.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.