Users Guide

Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route
map used in this command. If you identify a peer by IP address, the Route map overwrites either the
inbound or outbound policies on that peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor {ipv6-address | peer-group-name} route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration, use
the no neighbor {ipv6-address | peer-group-name} route-reflector-client
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group. All routers in the peer group receive routes from
a route reflector.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The first time you enter this command it configures the neighbor as a route reflector and members of the
route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you configure a
route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.
neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with that
attribute belong to the same community grouping.
Syntax
neighbor {ipv6-address | peer-group-name} send-community
To disable sending a COMMUNITY attribute, use the no neighbor {ipv6-address | peer-
group-name} send-community command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
876 IPv6 Border Gateway Protocol (IPv6 BGP)