Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000

871

872

873

874

875

876

877

878

879

880

neighbor peer-group (creating group)

Allows you to create a peer group and assign it a name.

Syntax

neighbor peer-group-name peer-group

To delete a peer group, use the no neighbor peer-group-name peer-group command.

Parameters

peer-group-name

Enter a text string up to 16 characters long as the name of the peer group.

Defaults Not configured.

Command Modes ROUTER BGP

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

FTOS Command Line Reference Guide.

The following is a list of the FTOS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.4.2.1 Introduced on the C-Series and S4810.

Version 8.2.1.0 Introduced on the E-Series ExaScale.

Version 7.4.1.0 Introduced on the E-Series TeraScale.

Usage

Information

When a peer group is created, it is disabled (shut mode).

Commands

neighbor peer-group (assigning peers) – assigns routers to a peer group.

neighbor remote-as – assigns a indirectly connected AS to a neighbor or peer group.

neighbor shutdown – disables a peer or peer group.

neighbor peer-group passive

Enable passive peering on a BGP peer group; that is, the peer group does not send an OPEN message, but does respond to one.

Syntax

neighbor peer-group-name peer-group passive

To delete a passive peer-group, use the no neighbor peer-group-name peer-group passive

command.