Users Guide

neighbor distribute-list
Distribute BGP information using an established prefix list.
Syntax
neighbor {ipv6-address | peer-group-name} distribute-list prefix-list-name
{in | out}
To delete a neighbor distribution list, use the no neighbor {ipv6-address | peer-group-
name} distribute-list prefix-list-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group.
prefix-list-name Enter the name of an established prefix list. If the prefix list is not configured, the
default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
neighbor filter-list – assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map – assigns a route map to a neighbor or peer group.
neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
Syntax
neighbor {ipv6-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ipv6-address | peer-group-
name} ebgp-multihop [ttl] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group.
ttl (OPTIONAL) Enter the number of hops as the time to live (ttl) value. The range is
from 1 to 255. The default is 255.
Defaults Disabled.
868 IPv6 Border Gateway Protocol (IPv6 BGP)