Users Guide

Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-group-name}
allowas-in command.
Parameters
ip-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group to set the advertisement interval for all routers in
the peer group.
number Enter a number of times to allow this neighbor ID to use the AS path. The range is
from 1 to 10.
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
bgp four-octet-as-support – enables 4-Byte support for the BGP process.
neighbor default-originate
Inject the default route to a BGP peer or neighbor.
Syntax
neighbor {ipv6-address | peer-group-name} default-originate [route-map map-
name]
To remove a default route, use the no neighbor {ipv6-address | peer-group-name}
default-originate [route-map map-name] command.
866 IPv6 Border Gateway Protocol (IPv6 BGP)