Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000
851852853854855856857858859860
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Entering a no debug ip bgp command removes all configured debug commands for BGP.
debug ip bgp ipv6 dampening
View information on dampened (non-active) IPv6 routes.
Syntax
debug ip bgp ipv6 unicast dampening [in | out]
To disable debugging, use the no debug ip bgp ipv6 unicast dampening command.
Parameters
in (OPTIONAL) Enter the keyword in to view only inbound dampened routes.
out (OPTIONAL) Enter the keyword out to view only outbound dampened routes.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Entering a no debug ip bgp command removes all configured debug commands for BGP.
Related
Commands
show ip bgp ipv6 unicast dampened-paths – views BGP dampened routes.
debug ip bgp ipv6 unicast soft-reconfiguration
Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast
soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-
group-name] ipv6 unicast soft-reconfiguration command.
Parameters
ipv4-address
|
ipv6-address
Enter the IP address of the neighbor on which you want to enable soft-
reconfiguration debugging.
858 IPv6 Border Gateway Protocol (IPv6 BGP)