Users Guide

soft (OPTIONAL) Enter the keyword soft to configure and activate policies without
resetting the BGP TCP session; that is, BGP Soft Reconfiguration.
NOTE: If you enter clear ip bgp ip6-address soft, both inbound
and outbound policies are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound policies.
out (OPTIONAL) Enter the keyword out to activate only outbound policies.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
clear ip bgp peer-group
Reset a peer-group’s BGP sessions.
Syntax
clear ip bgp peer-group peer-group-name
Parameters
peer-group-name Enter the peer group name to reset the BGP sessions within that peer group.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
clear ip bgp ipv6 dampening
Clear information on route dampening and return suppressed route to active state.
Syntax
clear ip bgp ipv6 unicast dampening [ipv6-address]
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format then the prefix length in the /x
format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Command Modes EXEC Privilege
854 IPv6 Border Gateway Protocol (IPv6 BGP)