Users Guide

Related
Commands
clear ip bgp ipv6 unicast soft – activates inbound policies for IPv6 routes without resetting the BGP TCP
session.
capture bgp-pdu max-buffer-size
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-102400000 Enter a size for the capture buffer.
Defaults 40960000 bytes
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
capture bgp-pdu neighbor (ipv6) – enables route reflection between the route reflector and the clients.
show capture bgp-pdu neighbor – configures a route reflector and clients.
capture bgp-pdu neighbor (ipv6)
Enable capture of an IPv6 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv6-address command.
Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both |
rx | tx}
Enter the keyword direction and a direction — either rx for inbound, tx for
outbound, or both.
Defaults Not configured.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
IPv6 Border Gateway Protocol (IPv6 BGP) 851