Users Guide

Command Modes ROUTE-MAP
Command
History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to accept up to 140
characters. Prior to version 7.8.1.0, the names are up to 16 characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
match ipv6 address – redistributes routes that match an IP address.
match ipv6 next-hop – redistributes routes that match the next-hop IP address.
route-map
Designate a IPv6 route map name and enter ROUTE-MAP mode.
C-Series, E-Series, S-Series
Syntax
route-map map-name
To delete a route map, use the no route-map map-name command.
Parameters
map-name Enter a text string to name the route map, up to 140 characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Command
History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to accept up to 140
characters. Prior to version 7.8.1.0, the names are up to 16 characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Example
Dell(conf)#route-map Rmap1
Dell(config-route-map)#match ?
…
ip IP specific information
ipv6 IPv6 specific information
…
Related
Commands
show config – views the current configuration.
set ipv6 next-hop
Configure a filter that specifies IPv6 address as the next hop.
C-Series, E-Series, S-Series
Syntax
set ipv6 next-hop ipv6-address
To delete the setting, use the no set ipv6 next-hop ipv6-address command.
810 IPv6 Access Control Lists (IPv6 ACLs)