Users Guide

Term Explanation
Portpipe Lists the portpipe (port-set) or port pipes (port-sets) that are checked. Entering
all shows the status for linecards and port-pipes in the chassis.
CAM Partition Shows the CAM profile of the CAM.
Available CAM Identifies the amount of CAM space remaining for that profile.
Estimated CAM
per Port
Estimates the amount of CAM space the listed policy requires.
Status Indicates whether or not the policy is allowed in the CAM
Example (C-
Series)
Dell#test cam-usage service-policy input LauraMapTest linecard all
Linecard|Portpipe|CAM Partition|Available CAM|Estimated CAM per Port|
Status
--------------------------------------------------------------
2| 1| IPv4Flow| 232| 0| Allowed
2| 1| IPv6Flow| 0| 0| Allowed
4| 0| IPv4Flow| 232| 0| Allowed
4| 0| IPv6Flow| 0| 0| Allowed
Dell#
Dell#test cam-usage service-policy input LauraMapTest linecard 4 port-set 0
Linecard|Portpipe|CAM Partition|Available CAM|Estimated CAM per Port|
Status
-------------------------------------------------------------
4| 0| IPv4Flow| 232| 0| Allowed
4| 0| IPv6Flow| 0| 0| Allowed
Dell#
Dell#test cam-usage service-policy input LauraMapTest linecard 2 port-set 1
Linecard|Portpipe| CAM Partition|Available CAM|Estimated CAM per Port|
Status
-----------------------------------------------------------------
2| 1| IPv4Flow| 232| 0| Allowed
2| 1| IPv6Flow| 0| 0| Allowed
Dell#
IPv6 Route Map Commands
The following commands allow you to configure route maps and their redistribution criteria.
match ipv6 address
Configure a filter to match routes based on IPv6 addresses specified in an access list.
C-Series, E-Series, S-Series
Syntax
match ipv6 address prefix-list-name
To delete a match, use the no match ipv6 address prefix-list-name command.
Parameters
prefix-list-name Enter the name of IPv6 prefix list, up to 140 characters.
Defaults Not configured.
Command Modes ROUTE-MAP
808 IPv6 Access Control Lists (IPv6 ACLs)