Users Guide

Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
ipv6 access-group AclList1 in implicit-permit Vlan 10-20
no shutdown
Dell(conf-if-te-1/1)#
ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
ipv6 access-list
Configure an access list based on IPv6 addresses or protocols.
Syntax
ipv6 access-list access-list-name cpu-qos
To delete an access list, use the no ipv6 access-list access-list-name command.
Parameters
access-list-name Enter the access list name as a string, up to 140 characters.
cpu-qos Enter the keyword cpu-qos to assign this ACL to control plane traffic only
(CoPP).
permit Enter the keyword permit to configure a filter to forward packets meeting this
condition.
deny Enter the keyword deny to configure a filter to drop packets meeting this
condition.
ospfv3 Specify that this ACL is for OSPFv3 control plane traffic
IPv6 Access Control Lists (IPv6 ACLs) 793