Users Guide

ipv6acl Set IPV6-ACL entries
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4> Number of FP blocks for IPV6 (multiples of 2)
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
Dell(conf)#
clear counters ipv6 access-group
Erase all counters maintained for the IPv6 access lists.
Syntax
clear counters ipv6 access-group [access-list-name]
Parameters
access-list-name (OPTIONAL) Enter the name of a configured access-list, up to 140 characters.
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series TeraScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale Added the monitor option.
deny
Configure a filter that drops IPv6 packets that match the filter criteria.
Syntax
deny {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
● Use the no seq sequence-number command syntax if you know the filter’s sequence number
● Use the no deny {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command
Parameters
ip-protocol-
number
Enter an IPv6 protocol number. The range is 0 to 255.
icmp Enter the keyword icmp to deny Internet Control Message Protocol version 6.
ipv6 Enter the keyword ipv6 to deny any Internet Protocol version 6.
tcp Enter the keyword tcp to deny the Transmission Control protocol.
udp Enter the keyword udp to deny the User Datagram Protocol.
Defaults Not configured.
Command Modes ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
IPv6 Access Control Lists (IPv6 ACLs) 787