Users Guide

stack-unit port-group portmode
Configure a fibre channel port group to enable passthrough ethernet mode.
S5000
Syntax
stack-unit unit-number port—group number portmode ethernet
To change to Fibre Channel mode, use the no stack-unit unit-number port—group number
portmode ethernet command.
Parameters
stack-unit unit-
number
Enter the keywords stack-unit then the unit number. The range is from 0 to 11.
port-group
number
Enter the keywords port-group then the number of the port-group. The range is
from 0 to 5.
portmode Enter the keyword portmode then the keyword ethernet to enable Ethernet
mode.
Command Modes CONFIGURATION
Command
History
Version 9.1(1.0) Introduced on the S5000.
Example
Dell(conf)#stack-unit 0 port-group 0 portmode ethernet
Changing port mode on slot 0 port-group 0 will make interface configs of
0 and 1 obsolete after a save and reload.
[confirm yes/no]:yes
Please save and reload for the changes to take effect.
Dell(conf)#
Related
Commands
show stack-unit port-group portmode — displays the fibre channel port-group mode information.
720 Fibre Channel Interface Commands