Users Guide

Defaults An FC port autosenses the speed of a peer FC port.
Command Modes INTERFACE FIBRE_CHANNEL
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When an FC port autosenses the speed of a peer FC port, it auto-negotiates to determine its speed.
To removed the configured port speed, enter the no speed {2G | 4G | 8G} command.
Example
Dell(conf)#interface fibrechannel 0/11
Dell(conf-if- fc-0/11)#speed 8g
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
show interfaces fibrechannel — displays the configuration of a Fibre Channel interface.
Passthrough Commands
The following are passthrough commands supported on the S5000.
show stack-unit port-group portmode
Display the fibre channel port-group mode information.
S5000
Syntax
show system stack-unit unit-number port-group portmode
Parameters
stack-unit unit-
number
Enter the keywords stack-unit then the unit number. The range is from 0 to 11.
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 9.1(1.0) Introduced on the S5000.
Example
Dell#show system stack-unit 0 port-group portmode
PortGroupId Ports Mode(Curr Boot) Mode(Next Boot)
0 0,1 FC FC
1 2,3 FC FC
2 4,5 ETH FC
3 6,7 FC ETH
4 8,9 FC FC
5 10,11 FC FC
Dell#
Related
Commands
stack-unit port-group portmode — configures a fibre channel port group to enable passthrough ethernet
mode.
Fibre Channel Interface Commands 719