Users Guide

If you configure the wavelength on a non-tunable optic, there is no change to the existing wavelength.
The configured wavelength is saved in the running configuration and is applicable, when a tunable optic is
used.
If you do not configure the wavelength on an inserted tunable optic, the existing wavelength is used.
Example
The following example shows the wavelength set for a tunable 10–Gigabit SFP+ optic:
Dell(conf-if-te-1/1)# wavelength 1528.30
Related
Commands
● show config — displays the interface configuration.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
Syntax
application {all | application-type}
To remove a management application configuration, use the no application {all |
application-type} command.
Parameters
application-type Enter any of the following keywords:
● For DNS, enter the keyword dns.
● For FTP, enter the keyword ftp.
● For NTP, enter the keyword ntp.
● For Radius, enter the keyword radius.
● For sFlow collectors, enter the keyword sflow-collector.
● For SNMP (traps and MIB responses), enter the keywords snmp .
● For SSH, enter the keyword ssh .
● For Syslog, enter the keyword syslog.
●
For TACACS, enter the keyword tacacs.
● For Telnet, enter the keyword telnet.
● For TFTP, enter the keyword tftp.
all Configure all applications.
Defaults None.
Command Modes EIS Mode (conf-mgmt-eis)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
Interfaces 679