Users Guide

Example (Single
Range)
This example shows a single range bulk configuration.
Dell(config)# interface range tengigabitethernet 5/3 - 23
Dell(config-if-range-te-5/3-23)# no shutdown
Dell(config-if-range-te-5/3-23#
Example
(Multiple Range)
This example shows how to use commas to add different interface types to a range of interfaces.
Dell(config-if)# interface range tengigabitethernet 5/1 - 5/23,
tengigabitethernet 1/1 - 1/2
Dell(config-if-range-te-1/1-2,te-5/1-23)# no shutdown
Dell(config-if-range-te-1/1-2,te-5/1-23)#
Example
(Multiple Range)
This example shows how to use commas to add VLAN and port-channel interfaces to the range.
Dell(config-if)# interface range tengigabitethernet 5/1 - 23,
tengigabitethernet 1/1 – 2,
Vlan 2–100, Port 1–25
Dell(config-if-range-te-1/1-2,te-5/1-23,vl-2-100,po-1-25)# no shutdown
Dell(config-if-range-te-5/1-24,te-1/1-2,vl-2-100,po-1-25)#
Related
Commands
● interface port-channel — configure a port channel group.
● interface vlan — configure a VLAN interface.
● show config (from INTERFACE RANGE mode) — display the bulk configuration interfaces.
● show range — display the bulk configuration ranges.
● interface range macro (define) — define a macro for an interface-range.
interface range macro (define)
Defines a macro for an interface range and then saves the macro in the running configuration.
Syntax
define interface range macro name interface , interface , ...
Parameters
name Enter up to 16 characters for the macro name.
interface,
interface,...
Enter the keywords interface range and the interface information. Select the
range of interfaces for bulk configuration. You can enter up to six comma-
separated ranges. Spaces are not required between the commas. Comma-
separated ranges can include VLANs, port-channels, and physical interfaces.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Interfaces 637