Users Guide

Command Modes INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command applies only to management interfaces with speed set to 10/100 Mb/s using the speed
command.
NOTE: When you set the speed to 10 or 100 Mbps, you can also execute the duplex command.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the primary or
standby stack-unit).
flowcontrol
Control how the system responds to and generates 802.3x pause frames on 10 Gig ports.
Syntax
flowcontrol rx {off | on} tx {off | on} [negotiate | pause-threshold |
resume-offset]
To return to the default, use the no form of this command.
Parameters
rx on Enter the keywords rx on to process the received flow control frames on this
port. This is the default value for the receive side.
rx off Enter the keywords rx off to ignore the received flow control frames on this
port.
tx on Enter the keywords tx on to send control frames from this port to the connected
device when a higher rate of traffic is received.
tx off Enter the keywords tx off so that flow control frames are not sent from this
port to the connected device when a higher rate of traffic is received.
Defaults
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
6.5.1.9 and
7.4.1.0
Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series with the thresholds option.
628 Interfaces