Users Guide

clear ip igmp snooping groups
Clear snooping entries from the group cache table.
S5000
Syntax
clear ip igmp snooping groups [group-address interface | interface]
Parameters
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface
interface
Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on S-Series and Z–Series.
Usage
Information
IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results.
debug ip igmp
Enable debugging of IGMP packets.
S5000
Syntax
debug ip igmp [vrf vrf-name] [group address | interface]
● To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name] [group address
| interface] command.
● To disable all debugging, use the undebug all command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable
debugging of IGMP packets corresponding to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface
interface
Enter the following keywords and the interface information:
Internet Group Management Protocol (IGMP) 599